Tuesday, April 30, 2013

New Owners for Mother's Day




My mother's house is now somebody else's. Not 24 hours after the closing, there were roofers spotted starting the replacement process by my dear cycling husband, who sent this photo during his ride. I am deeply grateful that the home my mother so loved will be cared for more diligently than she could manage in her waning years.
I am in a transitional time; with my mom's passing, and the sale of her house, (in a month!) my childhood is officially over. Also, four years prematurely, I am facing an empty nest in the fall as my youngest heads off to St. Paul's School. Ok, she will be only 4 miles down the road, but in every sense, she is growing up and leaving me, this child who stuck by my side so hungrily. I am stunned by the speed at which this toddler with wisdom grew into a responsible young adult, and I do not anticipate an easy good-bye.
My friend Jane cried for weeks after her son went to college. The intensity of her sense of loss surprised her, a level-headed, type A professional. I think it surprised her husband and the daughter who remained at home as well, though they weathered it with the love and indulgence that mothers deserve.
Without intending to, this ends up as a post for Mother's Day. I am taking a moment to reflect about the enormity of a mother's role in every human. Either from being a great mother, a flawed mother, or an absent mother, her influence can not be overestimated.

Saturday, April 20, 2013

Laundry Sorter Tutorial

I can't tell you how many years our laundry sorter has been ripped and impaired. I've looked for a new one, but have you seen the atrocities that are on offer? I just could not buy a butt-ugly laundry sorter knowing how long I'd be stuck with it. So, here is my brand new, fabulous sorter and a tutorial.

I used the frame I had, since it's strong and the wheels are still rolling well. The inner width is 29 1/2" so I planned to make each of the three laundry bags 10" wide, and about 14" deep. The height of my bags was about 24 1/2".

I can't tell you how great it felt to throw that old ripped sorter into the trash. Note how the ties are all broken and the separators are torn down the sides.

These were each less than $2 and plenty big enough to do the job. I got them at Walmart. They are 24" wide by 36" tall, though I didn't need that much height. I would say that you need at least 24" width, but could get away with 29 or 30" tall.


For each bag, I used 28" of fabric, assuming you can get at least 41" or so in usable width. Note that that's not enough to make it all the way around the mesh bag; if you use home dec fabric, you only need 21" of fabric. Cut two strips, 14" by WOF, (width of fabric.) Trim the selvedge, (sparingly,) off one of the pieces and measure what you have left. Subtract that number from 50. That's the width you need from the other piece in order to make this fit around the mesh bag bottom.

With the remaining 14" strip, cut off a selvedge edge and then cut a piece the width you've just calculated above. For example, I had 43" of usable fabric on my first fabric. Using the equation 50-43, I needed a 7" piece from the second strip. My second and third bags started with 41". I needed 9" pieces from the second strips on those.

Next, take the remaining second strip and cut a 25" wide piece, (by 14" long,) then cut that lengthwise in half to make two, 25" by 7" strips. The remaining fabric from that second strip will make your ties. If possible, cut 4 strips, 2" by 14" but if not, you can cheat and make them skinnier. No less than 1 1/2" though, I'd say. If you cut the other pieces sparingly, you should be fine.

Sew the 14" long pieces together along one of the 14" edges using 1/2" SA. Similarly, sew the 7" pieces together along one 7" edge, making sure that you keep directional prints the same direction. Press the seam open. While you have the iron hot, press the ties in half lengthwise, then each side into the center. Then press in half lenthwise as if you are making double fold bias tape.

At this point, if you want to use interfacing to stiffen the fabric components of your bag, apply fusible interfacing. I made the base of my first bag and then wished I'd used some interfacing so I added it to subsequent pieces. Truthfully, I'm not sure it matters. If you want to interface, use strips 13 1/2" long by WOF for the bases, and 6 1/2" by WOF for the upper rings. I had to piece interfacing onto the fabric but am too lazy to piece the interface before fusing it. It really doesn't matter. Complete the rings by sewing the ends together, right sides together, of both the 14" and 7" strips. Press seams open.

Press a  1/2" hem of the 14" section at the top* edge to wrong side, and a similar 1/2" hem at the bottom* of the 7" section, (also to the wrong side.)
*By "top" and "bottom," I am being careful here to make sure my print fabric ends up right side up. That matters only if you fabric is directional. Check out this photo: the narrower strip is going to be along the top edge of the laundry bag, and the wider strip is going to be at the base.

Sew along long and short edges of each of the ties, a scant 1/8" from the edges.

Lay out the mesh bag, inside out, and cut the bottom and top off. You need a 27 1/2" long tube, the full width of the bag; if your mesh bag has rounded corners at the bottom, try to use above that section. If you can't get 27 1/2" of full width, just slit up the curved seam so that the bottom opens all the way.


Place the fabric base, right side in, inside the (inside out) mesh bag, raw edges aligned. Pin carefully and sew through all 4 layers. I serged the bottom seam.











Now create the boxed bottom of the laundry sorter bag by aligning the side seam with the bottom seam that you've just created. Using a ruler, find the point along the seam where the width of side will be 10", and draw a line across the corner, perpendicular to the side seam. Sew across this line, backstitching at the ends, for strength. Do this to both bottom corners.





Before turning the bag right side out, take the opportunity to put a few pins in the bag to attach the fabric to the mesh at the pressed top of the fabric. Turn right side out and put more pins in to affix the mesh to the fabric. Topstitch the upper edge of the base fabric to the mesh bag on the right side.



Now, you can either cut off the base triangles leaving a 1/2" seam allowance, (Serge or zigzag this to finish,) or pin that triangle down into the base of the bag and stitch it down to offer a little extra bulk and stability. I sewed them down into the base.





With the bag now right side out, insert the upper fabric ring, right side out, so the raw edges are aligned. This feels weird because you are pinning the right side of the fabric to the wrong side of the mesh. Reassure yourself by checking; if you sew a 1/2" inch seam along this raw edge, will the fabric later flip around and fold down to make the ring with only right sides showing?






Topstitch!! Try to limit your smugness to just a few minutes, you smartypants!




Now, to attach the ties, I'd try the laundry bag on the rack by holding it up there and estimating where you want the corners to tie, and how well everything is going to fit together.  Pin those babies to where you think they belong, and sew them on securely to the corners, just right!!
Here's what I wish I had done differently: After measuring the width of the frame, I divided that into three for three bags, and rounded up to make the math nice. 29 1/2 inches, I figured, would accommodate three 10" wide bags, but after attaching the first two, I saw that the last spot was going to be, well, 1/2" too narrow for a 10" bag. I didn't pay any attention, and just went ahead and made a 10 inch wide bag. Now that I've done it, I wish I'd made the bags 9 3/4" wide so they'd fit perfectly. OR perhaps I should have put those ties on a little differently to make the bags squish into less width. That would have probably done the trick. So now I'm smarter but no less smug.






Northfield Mount Hermon

We just had another great "Family Day" at NMH. Apparent to us is that our "Lexi" is loved, and that is a joyful thing. Margaret van Baaren, Learning Specialist, is kind and insightful and sensitive. She, among others, makes that place the perfect place for our dear girl. So, I set out to find a quilt for her. Imagine my surprise to find all these quilts lying around without previous photos on my blog! Here they are...one of which will soon be off to a new home.

 Garden of Grace Table Topper, #4, 2008

Bento Box, #8, 2008


 Wickedly Wild Women of the West, #5, 2008

 From the bridesmaid dress I wore for Wendy's wedding, un-quilted, and un-numbered, maybe in 1989.


 Ogontz Wicked Loud Bugs, #12, 2008
 Flannel Posh Tot, #22, 2009

 Irises Snap 2, #10, 2008
Posh Tot Lacy, #14, 2008
Hip to Be Square, #47, 2010

Batik Strips, #28, 4/11/09

Sunday, April 14, 2013

Anthony's Laptop Case

Glow in the dark skeletons!
Most everything you make should make you smile.


Photographed with and without the lights on. If you knew Anthony, you'd know that this is perfect. Such a long life he's lived in his 14 years, yet all that is good in children remains in him. He has great potential as a boy turning into a man. 
Stash Used: 1 1/2 yards Stash used total: 89 3/4 yards
Stash acquired: 0 yards
Stash acquired total: 126.75 yards

Kelly's Sister's Bag


Kelly has two sisters, each of whom has a name, but I am not sure for which sister this bag is. I think it's adorable, in Laura Ashley prints, and a tiny hint of Sandy Gervais.




Stash Used: 1 1/8 yards
Stash used total: 88 1/4 yards
Stash acquired: 0 yards
Stash acquired total: 126.75 yards

Saturday, April 13, 2013

Mary's Bag

Mary had foot surgery and we never gave her a bag! Well, here is Mary's bag.



Stash Used: 1.5 yards
Stash used total: 87 1/8 yards
Stash acquired: 0 yards
Stash acquired total: 126.75 yards